H-100 Control Panel for Guardian Elite Generators

Home | email | Toll Free Toll Free | Buy Commercial Generators Online

Guardian | Guardian Elite | QuietSource | Commercial | Specs | Transfer Switches

H-100 Control Panel

DESCRIPTION

• Digital controls for all safety shutdowns

• Isochronous governor control built

• Sealed Digital Circuit Board

• 2 Amp static battery charger

• Mates with HTS transfer switch

STANDARD FEATURES

The H-100 Control Panel is a digital microprocessor electronic controller that integrates all engine and transfer switch functions into a single control system. Two 4 line x 20 displays
Full system status

3 phase sensing voltage regulator

Remote ports

- RS232

- RS485

- Canbus

Water proof connections

All engine sensors are 4-20 ma for minimal interference Built in PLC. In addition, the generator set parameters can be manipulated and monitored without standing in front of the control panel with GenLink® software. The Generac H-100 control also monitors and controls transfer switch functions when used with the HTS Transfer Switch.

Monitors utility voltage

Monitors generator voltage

Timer for line interrupt delay

Timer for engine warmup

Timer for minimum engine run time

Timer for return to utility position

Timer for engine cooldown

Built in exerciser timer (7 day)

Additional 2 wire start controls

FEATURES

QUIET-TEST™ H-100 Control

Full range stand-by operation

Shutdowns

Full system status

-Overvoltage

-3 phase AC volts

-Overspeed

-3 phase amps

-Low oil pressure

-kW

-High coolant temperature

-Power factor

-Low coolant level

-Reactive power

Remote communication

-Oil pressure

-RS232

-Water temperature

-Optional modem

-Water level

-Canbus

-Oil temperature (optional)

Complies with NFPA Level 2

-Fuel pressure

Programmable auto crank

-Engine speed

Emergency Stop

-Battery voltage

On Off Manual Switch

-Alternator frequency

Not in Auto flashing light

-Time

Audible alarm for fault condition

-Date

Transfer switch logic communicates with HTS transfer switch

-Transfer switch status

Weekly exerciser (programmable)

-Run hours

Selectable Low speed exercise

-Service reminders

Digital voltage regulator with 3 phase sensing (3 phase units)

-Trending

Isochronous governor

-Fault history (alarm log)

Waterproof electrical connectors

-I2t function for full generator protection

Temperature Range -40û to 70û C

-Built in PLC for special applications

TYPICAL CONTROL CONNECTION

*Ground wire is routed between generator and transfer switch, but is terminated only in H-100 Controller on generator.
See interconnection diagram on spec sheet and guidelines within owner's manuals.

H-100 Control Panel for Guardian Elite Generators | Home